SetAllDrives

Scope
Intended Audience
All X
CommVault Internal  
CE/System Test  
Development  

Release
  • 8.0.0

Description
This program disables or enables all the drives for Galaxy.

Usage
  1. Copy the executable to <Galaxy Install Directory>\Base.
  2. Open a command window, change the directory to <Galaxy Install Directory>\Base, and run SetAllDrives using the following syntax:
    SetAllDrives [-vm <virtual machine>] disable|enable
  3. If the drives are successfully set to the desired mode, notification will be given indicating the state that the drives were set to. If there are any errors, an appropriate message will be printed.

NOTE

  • The Galaxy Event Viewer will not show an event indicating that the drives were reset if done using this utility.

History
Revision Date Description
Revision 1 January 1, 2007 8.0.0 version

Disclaimer of Warranties

CommVault provides software tools and utilities on an "as is" basis, as a courtesy and convenience to its users, and they may be changed from time to time without notice. These tools and utilities are provided without express, implied, or statutory warranties of any kind. You assume full risk and responsibility for the selection, possession, performance and proper installation and use of the software tools and utilities, and for verifying the results obtained there from. Your use of CommVault software tools and utilities indicates your unconditional acceptance of the above disclaimer.