Getting Started - Snap Movement to Media

Skip this page if you are not using a Tape Device.

Click to Continue.

Backup Copy Operations

A backup copy operation provides the capability to copy snapshots of the data to any media. It is useful for creating additional standby copies of data and can be performed during the SnapProtect backup or at a later time.

Once a backup copy is performed and the snapshot is copied to media, the same snapshot cannot be re-copied again.

Inline Backup Copy

Backup copy operations performed during the SnapProtect backup job are known as inline backup copy. You can perform inline backup copy operations for primary snapshot copies and not for secondary snapshot copies. If a previously selected snapshot has not been copied to media, the current SnapProtect job will complete without creating the backup copy and you will need to create an offline backup copy for the current backup.

  Depending on the Agent you are using, your screens may look different than the examples shown in the steps below.
1.
  • From the CommCell Console, navigate to Client Computers | <Client> | <Agent> | defaultBackupSet.
  • Right click the default subclient and click Backup.
  • Select Full as backup type.
  • Click Advanced.
2.
  • Select Create Backup Copy immediately to create a backup copy.
  • Click OK.

Offline Backup Copy

Backup copy operations performed independent of the SnapProtect backup job are known as offline backup copy.

1.
  • From the CommCell Console, navigate to Policies | Storage Policies.
  • Right-click the <storage policy> and click All Tasks | Run Backup Copy.
2. Click OK.