Click on a link below to go to a specific section of the software installation:
Install Requirements |
The File Share Archiver Client is installed on any computer from which you
wish to recover files archived by the File Archiver
for Windows Agent (this computer is referred to as the Client computer in this
install procedure). Configurations utilizing an
FPolicy or Celerra instance
to perform recalls for archived data do not require the
File Share Archiver Client software. For more information, see
Instances - File Archiver. Verify that the computer in which you wish to install the software satisfies the minimum requirements specified in System Requirements - File Archiver for Windows. The following procedure describes the steps involved in installing the File Share Archiver Client. If you choose to install multiple components simultaneously, refer to the appropriate procedures for installation requirements and steps specific to the component. Note that when you install multiple components, the sequence of the install steps may vary. In order to use the File Share Archiver Client component, you must install the File Archiver for Windows Agent. See Deployment - File Archiver for Windows Agent for procedures on installing the File Archiver for Windows Agent. Do not install the File Share Archiver Client and the File Archiver for Windows Agent on the same computer. Review the following Install Requirements before installing the software: General
|
Before You Begin |
|
Install Procedure |
||
Getting Started |
||
1. |
Place the software
installation disc for the Windows platform into the disc drive.
|
|
2. | Reboot the computer after installation. | |
Post-Install Considerations |
||
General
|