Install the CommServe and Windows File System iDataAgent on the same Cluster Group

Before You Begin

Refer to the following:

• Notes on CommServe Installation

• Clustering Support

• Multi Instancing

To install the CommServe and Windows File System iDataAgent on the same cluster group:

1. Install the CommServe in the cluster group from the active node. Note that this installation will use Instance001. For installation procedures, see Install the CommServe - Clustered Environment.
2. Install the Windows File System iDataAgent on the physical computer that is the active node for the cluster group where you installed the CommServe in Step 1. Note that this installation will automatically create Instance002. For installation procedures, see Install the Microsoft Windows File System iDataAgent.
3. To allow Multi Instancing, configure the bAllowMultiInstances registry key on the same physical computer which is the active node for the cluster.
4. Install the Windows File System iDataAgent in the cluster group from the active node. For installation procedures, see Install the Microsoft Windows File System iDataAgent - Clustered Environment. Note the following:
   • In the Install Instance Selection screen, specify Instance002, where the Windows File System iDataAgent was already installed for the physical computer.
   • In the Communication Interface Name screen, specify a different Client Name and Interface Name from those already specified during the CommServe installation in the cluster group.
5. Refer to the Post-Install Considerations section of each of the installation procedures referenced here.